How To Paint A Ping Pong Table – Step By Step Guide Unveiled

"As an Amazon Associate I earn from qualifying purchases."

Paint is not just for wooden surfaces. It can be used on metal too! It’s not an easy task for people who are going to paint the table. This article will walk you through the process of how to paint a ping pong table step-by-step guide to getting the best results.

Remember that when using any type of paint, remember to take into account the surface area that needs to be painted and allow enough time for drying in between coats (usually around 12 hours).

As always, make sure to wear latex gloves and safety goggles while handling the paint and other hazardous chemicals in order to avoid skin irritation or chemical burns.

How to paint a ping pong table step by step guide

Step 1:

Preparation – Disassemble your ping pong table so that all pieces are accessible. Remove all loose hardware, springs, etc. You may want to wear protective gloves and safety goggles during this step.

Remember to take into account the surface area that needs to be painted, as well as allow enough time for drying between coats (usually 12 hours).

Your table should look something like this after you have completed all the steps of disassembly.

Step 2:

table tennis table cleaning
Table tennis table cleaning

Cleaning – Remove all dirt and debris from the table using soap, water, and a scrub brush. For tough residue spots use a grease-cutting detergent or degreaser. Rinse off the cleaning solution with running water. Allow the table to dry completely before moving on to the next step.

Step 3:

Measure – Now that the table is dry, measure out 1/8th of a cup of paint for each square foot of surface area you want to cover (use more paint if you are painting intricate patterns). Then pour this into your lidded plastic paint tray or another suitable container. If necessary, gently stir in a few mineral spirits to make the paint more easily pourable.

Step 4:

Painting – Use an off brush/roller to apply your first coat of paint. Work in small sections, roughly 12x12in at a time before moving onto the next section. Make sure the entire surface is covered and try not to get any runs or drips. If you do, just wipe them off with a rag and some mineral spirits before they dry. Allow the first coat to thoroughly dry before applying a second coat as needed. Avoid stirring the paint in between coats as this can cause unwanted bubbles or streaks!

Step 5:

Aftercare – Once your ping pong table is completely dry, reassemble it and PRESTO! You have a beautifully painted ping pong table. Make sure to store your brush in mineral spirits between uses so that it doesn’t become dry or brittle.

What kind of paint do you use on a ping pong table?

Ping Pong Table Painting
Ping Pong Table Painting

Paint is the most common surface protection for a ping pong table.

There are many different types of paint that can be used on a ping pong table, including latex and acrylic paints, epoxy sealers or clear coats, water-based or oil-based stains, and polyurethane finishes.

The type of paint you choose depends on your preference in color and durability.

Paint is usually applied by using an airless sprayer to reduce overspray onto other areas while painting the edges of the table with a brush to make sure no unpainted spots remain.

The painting should happen before any play begins so that the finish lasts longer without peeling off from wear and tear from balls hitting it.

Do you need to sand a Pong table before painting?

Sand a Pong table before painting
Sand with Paint

Pong tables are made of wood and you need to sand them before painting.

You can’t paint a Pong table without first sanding it thoroughly. It’s important not to skip this step because the paint will not adhere properly and will easily chip off, leaving your Pong table looking terrible.

The best way to do this is by using an orbital sander with medium-grit paper. Go over each surface in both directions until all the bumps and grooves have been smoothed out.

Then vacuum up any dust that has fallen on the floor as you’re working so that it doesn’t get mixed into the paint later on down the line when you go to apply it.

If there are any rough patches left after sanding, you may want to sand them again, but this time with fine-grit sandpaper.

Once you’ve sanded your Pong table, it’s then a good idea to fill any cracks that might exist on the surface of your table with wood filler.

This is an excellent way to ensure that all imperfections have been smoothed out, because the wood filler will fill up any holes, allowing you to sand it down smooth once more.

If your Pong table is in pretty good nick then this step may not be necessary, but it’s always a wise move to do so just in case there are any little cracks that you can’t see that may allow the paint to chip off later on down the line.

Can you repaint the ping pong table?

Yes, you can repaint a ping pong table. Ping pong tables are made of wood, which means they will wear over time. The paint can peel or chip with use.

You may want to repaint your ping pong table if the paint is peeling, chipping, or fading.

This will make it look new and protect it from further damage. If the paint has not yet started to peel off, you might be able to rejuvenate it by sanding and re-coating with a high-quality polyurethane varnish such as Minwax sealer/preservative.

You should use a 100% natural, water-based sealer and product instead of an oil-based one, which can trap moisture and cause damage.

Repainting Ping Pong Table
Ping Pong Table

9 Steps to follow to repaint your ping pong table:

1. Remove the net from the post to remove the tension from the table; this will make it easier to paint.

2. Use a putty knife to carefully scrape off all of the old paint; use masking tape to protect surrounding areas, if necessary.

3. Sand the surface; first use medium-grit sandpaper (220 or higher), then switch to fine-grit (240 or higher). When you are done sanding, remove the sanding dust by blowing it away with an air compressor or using a tack cloth. Wipe down the table with a solution of 50/50 white vinegar and warm water. Let dry thoroughly.

4. Use masking tape to protect surrounding areas that you don’t want to get paint on (e.g., the side of a house).

5. Tape a large rectangle of plastic wrap to the top of the table for easy cleanup before you paint. Then, apply paint to one side at a time; if necessary, use an extension pole to reach all parts of the table. Let dry before flipping and painting another side.

6. Use 3-inch wide masking tape to create stripes for the table.

7. Apply two coats of paint; let dry completely before removing paper and plastic wrap.

8. Use a sock on the end of a broomstick to apply several thin layers of varnish (or polyurethane) to protect and seal the wood; you can also use a spray or brush-on varnish.

9. Tape a piece of plastic wrap to the table and let it dry for 24 hours before remounting the net on the post.

Before repainting an old table, you might be happy to read reviews of the top-quality ping pong table. Because you may change your mind about avoiding the hassles of repainting a ping pong table.

How do you paint a plastic table?

There are many ways to paint a plastic table. One way would be to paint it with water-based latex house paint, but there are some disadvantages to this method.

Water-based paints require more coats than oil-based paints and may not adhere as well as oil-based paints do.

Another disadvantage of using water-based latex is that they have a shorter shelf life than oil-based paints which could lead to the color fading over time if exposed to light or high temperatures.

An alternative way of painting your table is by using an acrylic exterior polyurethane sealant. Which will give you good adhesion with fewer coats needed for coverage and can be used on both new or old tables with no prep work required beforehand.

What do you seal a painted Pong table with?

Pong tables are a great way to get people of all ages and skill levels playing together. They’re also an excellent way to teach younger players the basics of table tennis.

The best part is that they’re easy and inexpensive to make, and you can even paint them for decoration or special occasions!

But this doesn’t mean they should be left unprotected from spills, dirt, or grime. That’s why it’s important to apply a protective sealant before any games begin.

 Seal a painted Pong table
Table, Paddle & Ball

Here are some guidelines on how to do so:

1) Apply two coats of a sealant as soon as possible after painting your pong table with the first coat. This will help protect against staining and chipping while still allowing time for drying between coats;

2) Use a high-quality sealer meant for use on painted surfaces or plastics, but make sure it’s one that’s designed for outdoor use. Never use an indoor sealant because it won’t be able to stand up to the weather;

3) Make sure you apply your sealant in another well-ventilated area that’s away from your main work area. If you seal over the paint fumes, they won’t dissipate and will make you sick. Try to do this with a fan on or opening a window;

4) Allow each coat of sealer to dry for at least 4 hours before applying another coat. This will protect better against chips and cracking;

5) Be sure to wipe down the table with a damp cloth before applying your final coat. This will ensure an even and smooth surface;

6) Wait at least 12 hours after your final application of sealant before allowing anyone to play on the table. This is because it needs that much time to fully cure, and any contact before that can mess up your work;

8) Bring the table back inside after you’re done, but don’t keep it under direct sunlight. Pong tables are primarily made of plastic which means they tend to melt if kept in too much heat. This may not be a big deal if you’re putting them away for a few days, but it’s not advisable to keep them outdoors during the summer.

7) That’s it! Now you can enjoy your table with all of your friends and family without having to worry about spills or damage. Have fun!


The ping pong table is the perfect centerpiece for any party. It’s great to have a place where guests can play before dinner or games after dinner. It also provides an opportunity for your family members to bond over sports while you cook in peace.

When deciding on what color paint to use, consider the look of the room that will hold the table. If you’re looking for something bolder than white but don’t want anything too dark, go with red!

You’ll find yourself playing more often when there’s no need to worry about dusting later since this color won’t show dirt nearly as easily.

Any time spent maintaining doesn’t feel like wasted time if you enjoy using your new table so much! However, it is necessary how to paint a ping pong table whenever your existing table looks exhausted or damaged.